search

Veranda 181985 Manuel d'instructions

Naviguer en ligne ou télécharger Manuel d'instructions pour Non Veranda 181985. Veranda 181985 Instructions / Assembly Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 4
  • Table des matières
  • MARQUE LIVRES
    • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
4'X42" SPADED SCALLOPED PICKET GATE
ASSEMBLY INSTRUCTIONS AND INSTALLATION TIPS
Continue to push the picket through the bottom rail into the throat and
hole of the second rail (fig. 3). The second rail becomes the top rail of
the assembly. Stop when the tab in the bottom rail and the notch on
the picket align. DO NOT SNAP INTO PLACE.
Continue this process until all pickets are inserted into the rails with the
tabs and notches aligned (fig. 4).
Once all the pickets are in place, snap the rails into all the picket
notches using your hands or gently tap with a rubber mallet (fig. 5).
Step 1
Step 2
Step 3
NOTE: PicketLock
™
is a patent-pending technology that provides a
glue- and fastener-free connection between the pickets and rails. You
may spray soapy water onto components to help them slide more
easily into their corresponding channels. A non-marring rubber mallet
may also be used to gently tap components more firmly into place.
PLANNING:
Prior to construction, check with your local regulatory
agency for special code requirements in your area. Contact your
utility supplier to locate and mark underground lines.
Careful planning and measuring of your fence project is essential, as
moving posts after the concrete sets is extremely difficult.
To ensure the scallop is correct, arrange all of the pickets in order
according to the drawing above before you begin panel assembly.
You will assemble the panel by starting with one of the longest pickets at
either end of your picket arrangement, working toward the opposite end.
Take one of the rails and gently open up the throat with your hand or a
wooden wedge (fig. 1). This will become the bottom rail of the assembly.
Insert a picket into the throat of the rail and proceed through the
routered hole as shown. DO NOT SNAP INTO PLACE (fig. 2).
Actual size: 46"h x 41-1/2"w
Place gate jambs on both sides of the rails and place the hinges on
the gate jamb so they are aligned with the rails. Using the bracket as
a guide, drill the three (3) necessary 1/4" holes for the bracket bolts.
Repeat these steps for the hinged brackets as well (fig. 6). Ensure the
rails are fully inserted in the jamb before drilling. The bolts need to go
through the jamb and rail to function properly.
Slide the hinged bracket and bracket on the top and bottom of the gate
jambs. Attach hinges to jambs with the supplied through bolts. Connect
bolts with the supplied cap nuts. Ensure the gate is square before all
bolts are tight. When square, tighten all bolts with a 7/16" wrench.
Step 4
fig. 6
Items you may need:
• Soapy water
• Non-marring rubber mallet
• Wooden wedge
• Power drill
• 1/4" drill bit
• 7/16" wrench
• Shims
fig. 1 fig. 2
fig. 3 fig. 4
fig. 5
Vue de la page 0
1 2 3 4

Résumé du contenu

Page 1 - Items you may need:

4'X42" SPADED SCALLOPED PICKET GATEASSEMBLY INSTRUCTIONS AND INSTALLATION TIPSContinue to push the picket through the bottom rail into the t

Page 2 - Digging Post Holes

Measure to be sure you can install the gate to the post with approximately a 2" gap from the ground to the bottom of the gate. Align the rails on

Page 3

PUERTA CON ESTACAS DE PUNTA DE PICA FESTONEADAS ESPACIADAS 4'X42"INSTRUCCIONES DE MONTAJE Y CONSEJOS DE INSTALACIÓNContinúe empujando la est

Page 4 - Instalación de la puerta

Mida para asegurarse de que puede instalar la puerta al poste con una brecha de aproximadamente 2" desde el suelo hasta la parte inferior de la

Commentaires sur ces manuels

Pas de commentaire
Produits connexes et manuels pour Non Veranda 181985
Non Veranda 73012502 Guide d'installation   (8 pages)
Non Veranda CAP LIGHT 5 BLK KIT Guide d'installation   (1 pages)
Non Veranda FNS PKT G H 39 WC Guide d'installation   (7 pages)
Non Veranda FNS RL BKT G Manuel d'utilisation et d'entretien   (1 pages)
Non Veranda 73024515 Guide d'installation   (28 pages)
Non Veranda 73014098 Manuel d'instructions   (16 pages)
Non Veranda AG 363 S Steel Manuel d'instructions   (2 pages)
Non Veranda EF 02401 Manuel d'instructions   (27 pages)
Non Veranda 181979 Manuel d'instructions    (4 pages)
Non Veranda EF 00202 Guide d'installation   (24 pages)
Non Veranda FNS PKT D J 69 WC Manuel d'instructions   (1 pages)
Non Veranda 2211-F32T Manuel d'utilisation et d'entretien   (1 pages)
  • Hessaire Cavaliere LANAFORM Mad Dogg Athletics Brown Stove Works
  • Denon Amplificateurs audio Minox Non Makita Fournitures d'outils à main JBL Supports de haut-parleurs OK Lecteurs de DVD
  • Lg BP640 Brother HL 2040 Dell PowerVault 660F Canon Digital IXUS 990 IS Panasonic TXL32E30B
  • Denon AVR-2809 Manuel de l'utilisateur Sennheiser CU1 Manuel de l'utilisateur Philips 170B5 Manuel de l'utilisateur Samsung RS26MBZBL Manuel de l'utilisateur Kenwood KCA-RC527 Manuel de l'utilisateur